Can't pair my wireless headphones to the mobile device using NFC function

IMPORTANT: This article applies only to specific products and/or operating systems. Check Applicable Products and Categories for details.

Check if your wireless noise-cancelling headphones pair with your mobile device using the NFC™ function after completing each step.

1. Remove the headphones from the charging case and make sure they're turned on.
   • The headphones automatically turn off when they are placed in the charging case.
   • If the headphones are turned off, press the left and right buttons at the bottom for two seconds until the blue indicating lamps flash.
2. The NFC function of the mobile device should be set to On and the screen should be unlocked.
3. Keep the NFC logo of the mobile device close to the NFC logo of the charging case until the mobile device vibrates or plays a short sound.
   Note: The image used below is for a WF-1000XM3 model.

   

4. If the mobile device is in a protective case, remove the case.
5. NFC sensitivity may vary. If you can't pair the headphones using NFC, you may connect to the Bluetooth® signal of the headphones directly.